Cisco WAP200 Access Point - Rangebooster
Specifications:

Standards: IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS priority), 802.1q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2), 802.11e ready (wireless QoS), 802.11F (wireless roaming) 

Ports: 10BASE-T/100BASE-TX Ethernet, 12V DC power 

Buttons: Reset 

Cabling type: Unshielded twisted pair (UTP) Category 5 

LEDs: Power, PoE, Wireless, Ethernet 

Operating system: Linux 

Setup/Configuration: Web user interface Built-in web user interface for easy browser-based configuration (HTTP/HTTPS) 

Management 

SNMP version SNMP version 1, 2c, 3 

Event logging ● Email notification ● Remote syslog 

Web firmware upgrade Firmware upgradable through web browser 

Diagnostics: Flash, RAM, LAN, WLAN 

Dynamic Host Configuration Protocol (DHCP): DHCP client 

Operating Modes Access point: Access point mode, point-to-point bridge mode, point-to-multipoint bridge mode, repeater mode 

Wireless Spec/modulation: Radio and modulation type: 802.11b/DSSS, 802.11g/OFDM 

Channels Operating channels: 11 North America, 13 most of Europe (ETSI and Japan) 

External antennas: 2 (omnidirectional) SMA detachable 

Transmit power: Transmit power (adjustable) at normal temperature range: ● 802.11b: 18~19 dBm ● 802.11g: 14~15 dBm 

Antenna gain in dBi: 2 

Receiver sensitivity: 802.11.g: 54 Mbps at -72 dBm, 802.11.b: 11 Mbps at -85 dBm 

Security: WEP/WPA/WPA2 WEP 64-bit/128-bit, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT 

Access control Wireless connection control: MAC-based 

SSID broadcast: SSID broadcast enable/disable 

802.1X: IEEE 802.1X support 

Wireless client isolation: Wireless client devices can be isolated from each other either within an SSID or between 2 SSIDs 

Wireless Security Monitor: Scan and classify wireless devices in the network Report new client and access point joining network and suspicious network events (works together with Cisco WUSB 200, WMP200 or WPC200 business client adapters): ● Intrusion alarms (e.g., rogue client detected, spoofed MAC address) ● Denial-of-service alarms (e.g., duration attack, association table full) ● Vulnerability alarms (e.g., access point is not using encryption, access point is broadcasting SSID) ● Other alarms (e.g., low speed connection) 

Quality of Service QoS: ● 4 queues ● Wi-Fi Multimedia (WMM) wireless priority 

Dimensions: W x H x D 6.69 x 8.07 x 7.68 in. (170 x 205 x 195 mm) 
Unit weight: 0.88 lb (0.4 kg)  
Power: 12V 1A DC Input, and IEEE 802.3af compliant PoE 
Maximum power draw: 3.36W